Skip to content
  • Calendar
  • JOIN NOW
  • About
    • Contact
    • FAQs
    • Members Ts&Cs
    • General Ts&Cs
  • Articles
  • Members
    • Log In
    • Challenge Submissions
    • My Account
    • Guide to Zoom
    • Lost password
Woodturning360

Woodturning360

  • £0.00 0
  • Close

Category: December ’21: Wet Wood

December ’21 Challenge Round-Up

Published Tuesday, 21 December, 2021By Martin Saban-Smith
Categorized as December '21: Wet Wood, Members Work

Our members this month were challenged with turning a piece from wet wood. Again, those who took part showed off their creativity and produced some super pieces.

Natural Edge Ash Bowl

Published Monday, 20 December, 2021By Keith Appleby
Categorized as December '21: Wet Wood, Members Work

28% moisture content but no distortion

Maple Crotch Bowl

Published Sunday, 19 December, 2021By Max Kackstetter
Categorized as December '21: Wet Wood, Members Work

Maple crotch bowl turned green with thin walls and bark inclusions.

Wet Walnut

Published Sunday, 19 December, 2021By Greg Ellyson
Categorized as December '21: Wet Wood, Members Work

Once turned walnut 3/16″ thick by 17″ long.

Oaken Branch Pot

Published Sunday, 19 December, 2021By Adrian Olsen
Categorized as December '21: Wet Wood, Members Work

For this project I have used an oak branch (about 7” in diameter) which was felled in the late summer….. while initially I though I might get away with no…

Continue reading Oaken Branch Pot

Wet Cherry branch

Published Friday, 17 December, 2021By Tom Dullage
Categorized as December '21: Wet Wood, Members Work

I was just given a few pieces of cherry branch, cut down just few days ago, just along the road. I was aiming for a thinner bowl on this little…

Continue reading Wet Cherry branch

Wet work

Published Sunday, 12 December, 2021By Chris Arnold
Categorized as December '21: Wet Wood, Members Work

So nothing really great, after a screw based initial disaster I had to go to a cut off which was quite punky in areas. Ended up with lots of filler…

Continue reading Wet work

More wet Leylandii

Published Saturday, 11 December, 2021By Tom Dullage
Categorized as December '21: Wet Wood, Members Work

Another piece of the Leylandii. This time I did some wet sanding on the outside, but, once the inside was turned, it seemed a bit too delicate to do any…

Continue reading More wet Leylandii

Wet Leylandii pot

Published Saturday, 11 December, 2021By Tom Dullage
Categorized as December '21: Wet Wood, Members Work

The only wet wood I have at the moment is the 4-foot stump of a Leylandii I cut down for our son a while back. We had left the stump…

Continue reading Wet Leylandii pot

Wet Wood Blue Cedar Dish

Published Thursday, 9 December, 2021By James Cassidy
Categorized as December '21: Wet Wood, Members Work

A piece of wet turned blue cedar unfinished which has a thin wall base. It has only warped a little turning slightly oval. I was hoping that it would have…

Continue reading Wet Wood Blue Cedar Dish

No warp drive here!

Published Wednesday, 8 December, 2021By Ian Bennett
Categorized as December '21: Wet Wood, Members Work

A spalted silver birch bowl that I turned into a thin walled bowl, about 3mm. it started at about 25% but unfortunately it did not warp as much as I…

Continue reading No warp drive here!

‘Wet’ Wood Turning

Published Monday, 6 December, 2021By Richard AYers
Categorized as December '21: Wet Wood, Members Work

This piece of Silver Birch was growing 24 Hours earlier; Is that green enough. I got soaked doing it ! ~It is now wrapped in shavings (a la Mike Waldt)…

Continue reading ‘Wet’ Wood Turning

Maple Branch Flowers

Published Monday, 6 December, 2021By Max Kackstetter
Categorized as December '21: Wet Wood, Members Work

From a fresh cut maple branch. Twigs for stems. Just turned yesterday, so not sanded or finished.

Big Leaf Maple Natural Edge Bowl

Published Monday, 6 December, 2021By Dan Oliphant
Categorized as December '21: Wet Wood, Members Work

Okay, I promise this is the last of my turned green pieces!! This bowl is about 13 inches in diameter by 4 1/2 inches high with a wall thickness of…

Continue reading Big Leaf Maple Natural Edge Bowl

Big Leaf Hollow Form 2

Published Friday, 3 December, 2021By Dan Oliphant
Categorized as December '21: Wet Wood, Members Work

This hollow form was cut from the same blank as the other submission except that this one was turned side grain to show the visual difference. Right off the gauge,…

Continue reading Big Leaf Hollow Form 2

Big Leaf Maple Hollow Form

Published Monday, 29 November, 2021By Dan Oliphant
Categorized as December '21: Wet Wood, Members Work

Big leaf maple, approx. 7 inches by 4 inches, wall thickness is about 3/16 inch. This is a soft maple so it may move a lot. Turned end grain.

Pages

  • Challenge Submissions
  • Contact
  • FAQs
  • Members Work
  • My Courses
  • News
  • The WT360 Guide to Zoom
  • Your Location
  • Shop
  • Members Terms and Conditions
  • Logo Evolution
  • General Terms and Conditions
  • Privacy Policy
  • Your Team
  • Articles
© Copyright Hampshire Sheen Ltd, 2020. All rights reserved Copyright of members photos remains with them.